This quiz is comprised of 22 questions that will assess your knowledge of the EcoBurner Chafo and relevant safety features.
Which of the following is the best location to refill a Chafo?
In a clean dry sink
In a plastic basin
On a level counter top
The Chafo should be filled in a well-ventilated area away from naked flames and sources of ignition.
It is safe to fill the Chafo beside another lit Chafo?
The nozzle of the refill canister is correctly inserted into the filling valve and properly aligned when:
The yellow stripe on the can is facing you
You push down hard on the canister
You rotate the canister until the nozzle drops into place
Best performance is achieved by filling the Chafo when:
It has cooled down after service and returned to room temperature
5 minutes before service
It has warmed up during service
What should you do if a Chafo is overfilled?
No additional actions are required and the Chafo can be placed below a chafing dish.
Turn to the ON position and allow the excess fuel to disperse into the air
Turn to the ON position, light the Chafo and allow the excess fuel to burn off in a safe area
Which of the following depicts the correct filling position?
When the temperature of the location in which the Chafo is being used increases above 22°C or 72°F, the Chafo will:
The Chafo is not affected by ambient temperature
Approximately how long does it take to fill an empty Chafo?
The maximum weight of a full Chafo is?
350g / 12oz
320g / 11oz
420g / 15oz
The item attached to the filling station by a chain is for:
Resetting the OTV (over temperature valve)
To help keep the filling station balanced
Resetting the scales to zero
Which of the following depicts the correct method for lighting the Chafo?
During service the level of water should not fall below:
Water is only required initially.
2cm or ¾ inch
3.5cm / 1.5 inches
To reset the Overturned safety device (OSD), you should:
Shake the Chafo and then relight
Turn the Chafo upright and wait five seconds
Turn the Chafo upright, move the dial to the OFF position
All of the above
Which of the following depicts the Over Temperature Valve safety device (OTV) in its Activated position?
To reset the Over Temperature Valve safety device (OTV), you should:
Turn the control dial fully clockwise to the OFF position
Leave the Chafo return to ambient temperature
Use a the OTV reset tool or narrow bladed implement to push the OTV indicator down
What is the main cause of activating the Over Temperature Valve (OTV) safety device?
The Chafo is low in fuel
When the Chafo is not in use, how should it be stored?
Stored upside down on a flat surface in the ON position
Stored upside down on a flat surface in the OFF position
Stored right way up on a flat surface in the OFF position
What is the best method for determining if the Chafo is full?
Weigh it using the Ecoburner filling station
Check the weight on any scales (420g / 15oz)
Either of the above
To ensure optimum performance, how far should the burner head be from the bottom of the chafing dish?
3 cm / 1 ¼ inches
1.5cm / 5/8ths of an inch.
There is no recommended distance.
If the Chafo will not light what should you do?
Check if Over temperature valve safety device (OTV) is engaged, then weigh Chafo to check fuel level.
Add fuel – if the Chafo won’t light it’s because it’s out of fuel.
Shake the Chafo to reset the OTV.
Can the Chafo be used side by side with another heat source (e.g. gel / wick) under the same chafing dish?
Please press the Submit button below to check your answers.
Please fill in your details below to be sent our product quiz
Turks & Caicos
United Arab Emirates